Rohde & Schwarz FSW43 - Page 367

Common Measurement Settings
R&S
®
FSW
367User Manual 1173.9411.02 ─ 19
External Mixer State....................................................................................................367
RF Start / RF Stop.......................................................................................................367
Handover Freq............................................................................................................ 368
Band............................................................................................................................368
RF Overrange............................................................................................................. 368
Preset Band................................................................................................................ 368
Mixer Type.................................................................................................................. 368
Mixer Settings (Harmonics Configuration).................................................................. 368
└ Harmonic Type..............................................................................................369
└ Range 1/2..................................................................................................... 369
└ Harmonic Order............................................................................................ 369
└ Conversion loss............................................................................................ 369
External Mixer State
Activates or deactivates the external mixer for input. If activated, "ExtMix" is indicated
in the channel bar of the application, together with the used band (see "Band"
on page 368).
Remote command:
[SENSe:]MIXer[:STATe] on page 868
RF Start / RF Stop
Displays the start and stop frequency of the selected band (read-only).
The frequency range for the user-defined band is defined via the harmonics configura-
tion (see "Range 1/2" on page 369).
For details on available frequency ranges see table 11-5.
Remote command:
[SENSe:]MIXer:FREQuency:STARt? on page 870
[SENSe:]MIXer:FREQuency:STOP? on page 871
Data Input and Output