Rohde & Schwarz FSW43 - Page 473

Common Analysis and Display Functions
R&S
®
FSW
473User Manual 1173.9411.02 ─ 19
General Spectrogram Settings
This section describes general settings for spectrogram display. They are available
when you press the TRACE key and then select the "Spectrogram Config" softkey.
State............................................................................................................................473
Selecting a frame to display........................................................................................473
History Depth.............................................................................................................. 474
Timestamp.................................................................................................................. 474
Color Mapping.............................................................................................................474
Continuous Sweep/RUN CONT..................................................................................474
Single Sweep/ RUN SINGLE...................................................................................... 474
Clear Spectrogram......................................................................................................475
State
Activates and deactivates the spectrogram result display
Remote command:
CALCulate:SGRam|SPECtrogram[:STATe] on page 917
Selecting a frame to display
Selects a specific frame, loads the corresponding trace from the memory, and displays
it in the Spectrum window.
Note that activating a marker or changing the position of the active marker automati-
cally selects the frame that belongs to that marker.
This function is only available in single sweep mode or if the sweep is stopped, and
only if a spectrogram is selected.
The most recent frame is number 0, all previous frames have a negative number.
For more information see "Time Frames" on page 459.
Remote command:
CALCulate:SGRam|SPECtrogram:FRAMe:SELect on page 915
Trace Configuration