Rohde & Schwarz FSW43 - Page 698

Remote Commands
R&S
®
FSW
698User Manual 1173.9411.02 ─ 19
Manual operation: See "Ch Power ACLR" on page 112
See "C/N, C/No" on page 112
See "OBW" on page 113
See "Spectrum Emission Mask" on page 113
See "C/N" on page 186
See "C/No" on page 186
CALCulate<n>:MARKer<m>:FUNCtion:POWer:SELect <MeasType>
This command selects a power measurement and turns the measurement on.
Parameters:
<MeasType> ACPower | MCACpower
Adjacent channel leakage ratio (ACLR) aka adjacent channel
power or multicarrier adjacent channel.
The R&S FSW performs the measurement on the trace selected
with [SENSe:]POWer:TRACe.
CPOWer
Channel power measurement with a single carrier.
The R&S FSW performs the measurement on the trace selected
with [SENSe:]POWer:TRACe.
OBANdwidth | OBWidth
Occupied bandwidth measurement.
The R&S FSW performs the measurement on the trace that
marker 1 is positioned on.
CN
Carrier-to-noise ratio measurement.
CN0
Carrier-to-noise ratio measurement referenced to 1 Hz band-
width
Manual operation:
See "Ch Power ACLR" on page 112
See "C/N, C/No" on page 112
See "OBW" on page 113
See "C/N" on page 186
See "C/No" on page 186
CALCulate<n>:MARKer<m>:FUNCtion:POWer[:STATe] <State>
This command turns a power measurement on and off.
You can select a particular power measurement with CALCulate<n>:MARKer<m>:
FUNCtion:POWer:SELect.
Parameters:
<State> ON | OFF
*RST: OFF
Manual operation: See "C/N" on page 186
See "C/No" on page 186
Configuring and Performing Measurements