Remote Commands
R&S
®
FSW
707User Manual 1173.9411.02 ─ 19
11.5.3.4 Selecting the Reference Channel
The following commands define the reference channel for relative ACLR measure-
ments.
[SENSe:]POWer:ACHannel:REFerence:AUTO ONCE....................................................... 707
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:AUTO................................................707
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:MANual............................................. 707
[SENSe:]POWer:ACHannel:REFerence:AUTO ONCE
This command sets the channel power as the reference for relative ACLR measure-
ments.
Example:
POW:ACH:REF:AUTO ONCE
Usage: Event
Manual operation: See "Setting a Fixed Reference for Channel Power Measure-
ments (Set CP Reference)" on page 154
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:AUTO <RefChannel>
This command selects the reference channel for relative measurements.
You need at least one channel for the command to work.
Parameters:
<RefChannel> MINimum
Transmission channel with the lowest power
MAXimum
Transmission channel with the highest power
LHIGhest
Lowest transmission channel for lower adjacent channels and
highest transmission channel for upper adjacent channels
Example:
POW:ACH:REF:TXCH:AUTO MAX
Selects the channel with the peak power as reference channel.
Manual operation: See "Reference Channel" on page 152
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:MANual <ChannelNumber>
This command defines a reference channel for relative ACLR measurements.
You need at least one channel for the command to work.
Note that this command is not available for MSR ACLR measurements (see
CALCulate<n>:MARKer<m>:FUNCtion:POWer:PRESet on page 700).
Parameters:
<ChannelNumber> Range: 1 to 18
*RST: 1
Configuring and Performing Measurements
To Next Page
Loading...
