Rohde & Schwarz FSW43 - Page 708

Remote Commands
R&S
®
FSW
708User Manual 1173.9411.02 ─ 19
Manual operation: See "Reference Channel" on page 152
11.5.3.5 Checking Limits
The following commands configure and query limit checks for channel power and
ACLR measurements.
The results of the power limit checks are also indicated in the STAT:QUES:ACPL sta-
tus registry (see "STATus:QUEStionable:ACPLimit Register" on page 636).
CALCulate:LIMit:ACPower:ACHannel:ABSolute................................................................708
CALCulate:LIMit:ACPower:ACHannel:ABSolute:STATe..................................................... 708
CALCulate:LIMit:ACPower:ACHannel[:RELative]...............................................................709
CALCulate:LIMit:ACPower:ACHannel:RESult?..................................................................709
CALCulate:LIMit:ACPower:ACHannel[:RELative]:STATe....................................................709
CALCulate:LIMit:ACPower:ALTernate<ch>:ABSolute........................................................ 710
CALCulate:LIMit:ACPower:ALTernate<ch>:ABSolute:STATe............................................. 710
CALCulate:LIMit:ACPower:ALTernate<ch>[:RELative].......................................................710
CALCulate:LIMit:ACPower:ALTernate<ch>:RESult?.......................................................... 711
CALCulate:LIMit:ACPower:ALTernate<ch>[:RELative]:STATe............................................ 711
CALCulate:LIMit:ACPower[:STATe]................................................................................. 711
CALCulate:LIMit:ACPower:ACHannel:ABSolute <LowerLimit>, <UpperLimit>
This command defines the absolute limit of the adjacent channels.
If you have defined an absolute limit as well as a relative limit, the R&S FSW uses the
lower value for the limit check.
Parameters:
<LowerLimit>,
<UpperLimit>
The first value defines the limit of the lower adjacent channel,
the second value the limit of the upper adjacent channel.
Range: -200 dBm to 200 dBm
*RST: -200 dBm
Manual operation: See "Limit Checking" on page 157
See "Limit Checking" on page 170
CALCulate:LIMit:ACPower:ACHannel:ABSolute:STATe <State>
This command turns the absolute limit check for the adjacent channels on and off.
You have to activate the general ACLR limit check before using this command with
CALCulate:LIMit:ACPower[:STATe].
Parameters:
<State> ON | OFF
*RST: OFF
Configuring and Performing Measurements