Rohde & Schwarz FSW43 - Page 730

Remote Commands
R&S
®
FSW
730User Manual 1173.9411.02 ─ 19
CALCulate:LIMit:ESPectrum:RESTore............................................................................. 730
[SENSe:]ESPectrum<sb>:PRESet[:STANdard]................................................................. 730
[SENSe:]ESPectrum<sb>:PRESet:RESTore.....................................................................730
[SENSe:]ESPectrum<sb>:PRESet:STORe....................................................................... 731
CALCulate:LIMit:ESPectrum:RESTore
This command restores the predefined limit lines for the selected Spectrum Emission
Mask standard.
All modifications made to the predefined limit lines are lost and the factory-set values
are restored.
Example:
CALC:LIM:ESP:REST
Resets the limit lines for the current Spectrum Emission Mask
standard to the default setting.
[SENSe:]ESPectrum<sb>:PRESet[:STANdard] <Standard>
This command loads a measurement configuration.
Standard definitions are stored in an xml file. The default directory for SEM standards
is C:\r_s\instr\sem_std.
Suffix:
<sb>
.
1 | 2 | 3
Sub block in a Multi-SEM measurement
Parameters:
<Standard> String containing the file name.
If you have stored the file in a subdirectory of the directory men-
tioned above, you have to include the relative path to the file.
Return values:
<Standard> The query returns the name of the currently loaded standard.
Manual operation: See "Standard / MSR Settings" on page 216
See "Load Standard" on page 223
[SENSe:]ESPectrum<sb>:PRESet:RESTore
This command restores the default configurations of predefined SEM standards.
Note that the command will overwrite customized standards that have the same name
as predefined standards.
Suffix:
<sb>
.
1 | 2 | 3
Sub block in a Multi-SEM measurement
Usage: Event
Manual operation: See "Restore Standard Files" on page 224
Configuring and Performing Measurements