Roland FR-4X - Page 36

36
Using Sets
7. Press the [
J
] button to access the “SET File” screen.
8. Use the [–] [+] buttons to specify SET File.
Choose from the values in the table below.
Parameter/
Display
Value Explanation
SET File
All
Select “ALL” to import All Sets.
Also the system parameters will
be imported together.
NOTE
Selecting this function all Sets in
the FR-4x internal memory will be
replaced.
Single
Select “Single” to import the
single Set.
If you selected “ALL”
a. Press the [
J
] button.
The screen indicates the location in the “MySET” folder on the USB
flash drive.
MEMO
If there is no “MySET” folder, the root folder is shown.
If you want to move to another folder, refer to “How to select
the folder” (p. 36).
How to select the folder
1. To open an existing folder, select it by press
the [–] [+] button, then press the [ENTER/YES]
button.
Lower line of the screen “FLDR” display, it means that the
upper line of the name is a folder.
2. Press the [EXIT/NO] button to return to a higher
level (i.e. leave the current folder).
Press the [EXIT/NO] button at root folder to return to the
original screen.
b. Use the [–] [+] buttons to select a file with the “FR4”
file name extension.
0 0
If the file name does not fit in the screen, it scrolls.
c. Press the [
J
] button.
A confirmation message appears.
If you decide to cancel, press the [EXIT/NO] button.
d. Press the [ENTER/YES] button.
The display shows the importing is in progress.
When the import is completed, the screen indicates “Complete.”
&
If you selected “Single”
a. Press the [
J
] button.
The Dest SET screen appears.
b. Use the [–] [+] buttons to specify the import-
destination set number.
c. Press the [
J
] button.
The screen indicates the location in the “MySET” folder on the USB
flash drive.
MEMO
If there is no “MySET” folder, the root folder is shown.
If you want to move to another folder, refer to “How to select
the folder” (p. 36).
d. Use the [–] [+] buttons to select a file with the “ST4”
file name extension.
0 0
If the file name does not fit in the screen, it scrolls.
e. Press the [
J
] button.
A confirmation message appears.
If you decide to cancel, press the [EXIT/NO] button.
f. Press the [ENTER/YES] button.
The display shows the importing is in progress.
When the import is completed, the screen indicates “Complete.”
&