Roland FR-4X - Page 58

58
Menu Options
Parameter Explanation/Value
Rev Send
(Reverb Send)
Cho Send
(Chorus Send)
(Not for VTW Organ Tone)
Use these parameters to set the Reverb
or Chorus send levels (how much effect
should be applied to the Orchestra Bass
section).
0–127
0–127
Attack
(Attack time)
Decay
(Decay time)
Release
(Release time)
Cutoff
(Cutoff)
Reso
(Resonance)
Vib Dly
(Vibrato Delay)
Vib Dept
(Vibrato Depth)
Vib Rate
(Vibrato Rate)
(Not for VTW Organ Tone)
&
“Right Hand Orchestra Part
Parameters (Orchestra Edit)” (p. 53)
-64–0–+63
-64–0–+63
-64–0–+63
-64–0–+63
-64–0–+63
-64–0–+63
-64–0–+63
-64–0–+63
ExpPedal
(Expression Pedal)
Select “Off ” If you want to use the
bellows for expressive purposes.
Select “On” if you want control
the expression by foot purchasing
an optional MIDI foot controller
(e.g. FC-300).
Off, On
Touch
(Touch)
(Not for VTW Organ Tone)
This parameter allows you to specify
the velocity sensitivity of the Left Hand
section keys when they are used to play
Orchestral Bass sounds.
NOTE
5 Only when you select a tone that can be
controlled only by the keyboard, you can
set the “Touch” (When a tone that can
not be set is selected it will be displayed
as “----”).
For details regarding these sounds
refer to the “Tone & Drum Kit List”
supplementary manual.
&
http://www.roland.com/manuals/
5 It has no effect on the VTW Organ
sounds.
5 There are several sounds which
the difference in the velocities is
incomprehensible.
“FIX.L (Fixed Low)”: The
velocity value will always
be 50 (0x32) regardless of
the strength with which
you play the keyboard.
Parameter Explanation/Value
Touch
(Touch)
“FIX.M (Fixed Med)”: The
velocity value will always
be 80 (0x50) regardless of
the strength with which
you play the keyboard.
“FIX.H (Fixed High)”: The
velocity value will always
be 127 (0x7F) regardless
of the strength with which
you play the keyboard.
“LOW (Low)”: The velocity
value will not be less than
33 (0x21) even when
you play the most weak
keyboard. You get a certain
amount of volume even
if you play lightly on the
keyboard.
“MED (Medium)”: The
velocity value will not be
less than 17 (0x11) even
when you play the most
weak keyboard. This is the
middle of the “Low”and
the “High.”
“HIGH (High)”: The
velocity value is controlled
in the range of 1 (0x01) ~
127 (0x7F) by the strength
with which you play the
keyboard.This setting is
the most wide range of
velocity control.
“F.L+B (Fixed
Low+Bellows)”: You will
control the velocity in the
movement of the bellows
at the timing you play the
keyboard. However, the
velocity value will not be
less than 20 (0x14).
“F.M+B (Fixed
Med.+Bellows)”: You will
control the velocity in the
movement of the bellows
at the timing you play the
keyboard. However, the
velocity value will not be
less than 50 (0x32).
“F.H+B (Fixed
High+Bellows)”: You will
control the velocity in the
movement of the bellows
at the timing you play the
keyboard. However, the
velocity value will not be
less than 80 (0x50).
“BELW (Bellows)”: You will
control the velocity in the
movement of the bellows
at the timing you play the
keyboard.
Poly
(Polyphonic)
(Not for VTW Organ Tone)
For details, refer to “Orchestra Edit -
Poly/Mono” (p. 55)/”Orchestra Edit -
Portament Time” (p. 55).
PortTime
(Portamento Time)