Cutting the Same Object Repetitively
Replot
The data received from the computer can be saved to the machine's memory. This data can then be recut. To
recut, use the [REPLOT] menu in the display menu.
All the data received from the time the machine is put in the setup condition to the time the setup condition
is canceled is saved.
The data is not cleared even when the setup condition is canceled.
If the setup condition is canceled and the machine is then put back in the setup condition again, the data that
was saved is overwritten with the new data that is sent from the computer.
All data is cleared when the power is turned off.
If the data stored in the machine's memory exceeds 2 MB, recutting cannot be performed until the data has
been cleared. If [REPLOT] is carried out in this condition, [DATA OVERFLOW] appears. If no data is stored in the
machine's memory, [NO DATA] appears when [REPLOT] is selected from the menu.
Procedure
Step 1: Prepare the Data for Recutting
Step 2: Perform Recutting
To Next Page
Loading...
Need help?
General
