Roland GR-540 - Creating Cutting Data (1); (1) Start CutStudio; (2) Set the Model

Creating Cutting Data (1)
(1) Start CutStudio
Use CutStudio cutting software to create cutting data.
If CutStudio is not installed, click here.
If you are using a Macintosh, click here.
Procedure
Start CutStudio.
Windows 10 and Windows 7
On the Start menu, click All Programs (or Programs), click Roland CutStudio, and then click CutStudio.
Windows 8.1
At the lower left of the Start screen, click to display the Apps screen. Click .
CutStudio starts.