Roland JUNO-X - Correspondence between Controllers and Parameters; Ä Juno-X

27
Section Controller Parameter
Destination or
operation when used
with the [SHIFT] button
PORTAMENTO
1
ON Select PORTA ON
JUNO-X TONE EDIT:
PORTA MODE
2
TIME PORTA TIME
JUNO-X TONE EDIT:
PORTA TIME
LFO
3
PITCH Select PITCH LFO -
4
FILTER Select FILTER LFO -
5
AMP Select AMP LFO -
6
TYPE LFO WAVEFORM
JUNO-X TONE EDIT:
LFO WAVEFORM
7
RATE
If “LFO SYNC” is OFF
LFO RATE
JUNO-X TONE EDIT:
LFO RATE
If LFO SYNC is ON
LFO NOTE
JUNO-X TONE EDIT:
LFO NOTE
8
DELAY TIME LFO DELAY TIME
JUNO-X TONE EDIT:
LFO DELAY TIME
9
DEPTH
If “PITCH LFO” is selected
OSC LFO MOD
JUNO-X TONE EDIT:
OSC LFO MOD
If “FILTER LFO” is selected
FILTER MOD
JUNO-X TONE EDIT:
FILTER MOD
If “AMP LFO” is selected
AMP MOD
JUNO-X TONE EDIT:
AMP MOD
OSC
10
SUPER SAW
Select SUPER SAW
ON
JUNO-X TONE EDIT:
SUPER SAW
11
PWM/MOD
If SUPER SAW is OFF
PULSE WIDTH MOD
JUNO-X TONE EDIT:
PULSE WIDTH MOD
If SUPER SAW is ON
SSAW DETUNE
JUNO-X TONE EDIT:
SSAW DETUNE
12
If SUPER SAW is OFF
PW LEVEL
JUNO-X TONE EDIT:
PW LEVEL
If SUPER SAW is ON
SSAW LEVEL
JUNO-X TONE EDIT:
SSAW LEVEL
13
SAW LEVEL
JUNO-X TONE EDIT:
SAW LEVEL
14
SUB SUB LEVEL
JUNO-X TONE EDIT:
SUB LEVEL
15
NOISE NOISE LEVEL
JUNO-X TONE EDIT:
NOISE LEVEL
16
PITCH OSC PITCH
JUNO-X TONE EDIT:
OSC PITCH
DETUNE OSC DETUNE (*1)
JUNO-X TONE EDIT:
OSC DETUNE
HPF
17
FREQ HPF-STEP
JUNO-X TONE EDIT:
HPF-STEP
Section Controller Parameter
Destination or
operation when used
with the [SHIFT] button
FILTER
18
[R]
Select FILTER TYPE
JUNO-X TONE EDIT:
VINTAGE FLT TYPE
19
[M]
20
[S]
21
FREQ CUTOFF
JUNO-X TONE EDIT:
CUTOFF
22
RES RESONANCE
JUNO-X TONE EDIT:
RESONANCE
23
KYBD FLT KEY FOLLOW
JUNO-X TONE EDIT:
FLT KEY FOLLOW
AMP
24
GATE Select G-AMP
JUNO-X TONE EDIT:
AMP ENV SEL
25
LEVEL AMP LEVEL
JUNO-X TONE EDIT:
AMP LEVEL
ENV
26
PITCH Select PITCH ENV -
27
FILTER Select FILTER ENV -
28
AMP Select ENV F&A -
29
A
If “PITCH ENV” is selected
PENV ATTACK
JUNO-X TONE EDIT:
PENV ATTACK
If “FILTER ENV” and “ENV
F&A” are selected
ENV ATTACK
JUNO-X TONE EDIT:
ENV ATTACK
30
D
If “PITCH ENV” is selected
PENV DECAY
JUNO-X TONE EDIT:
PENV DECAY
If “FILTER ENV” and “ENV
F&A” are selected
ENV DECAY
JUNO-X TONE EDIT:
ENV DECAY
31
S
If “PITCH ENV” is selected
PENV SUSTAIN
JUNO-X TONE EDIT:
PENV SUSTAIN
If “FILTER ENV” and “ENV
F&A” are selected
ENV SUSTAIN
JUNO-X TONE EDIT:
ENV SUSTAIN
32
R
If “PITCH ENV” is selected
PENV RELEASE
JUNO-X TONE EDIT:
PENV RELEASE
If “FILTER ENV” and “ENV
F&A” are selected
ENV RELEASE
JUNO-X TONE EDIT:
ENV RELEASE
33
DEPTH
If “PITCH ENV” is selected
PENV DEPTH
JUNO-X TONE EDIT:
PENV DEPTH
If “FILTER ENV” and “ENV
F&A” are selected
FLT ENV DEPTH
JUNO-X TONE EDIT:
FLT ENV DEPTH
PART/FUNC
34
MONO Select SOLO
JUNO-X TONE EDIT:
KEY MODE
35
UNISON Select UNISON
JUNO-X TONE EDIT:
KEY MODE
(*1): Only enabled in FUNC mode.
* For other parameters, refer to “Parameter Guide” (PDF).
Correspondence Between Controllers and Parameters
JUNO-X
6
7
1
2
12 14 16 17 15 11 23
24
13
10
8 9 21 22
33
34 35
29 30 31 32
18
19 3 4 5 20 25 26 27 28