Roland JUNO-X - Error Messages

50
Error Messages
Message Explanation
Messages that disappear after a timeout
No TONEs.
When you press a model bank button, there is no tone to
recall.
MIDI Oine! The MIDI connection is broken.
MIDI Buer Full! The MIDI IN connector’s input buer has overowed.
MIDI CommunicationError! A hardware error occurred at the MIDI IN/OUT connector.
Messages that disappear when you press the [EXIT] button
Read Error! An error occurred when reading from a USB ash drive.
Write Error! An error occurred when writing to a USB ash drive.
USB Memory Not Ready! The USB ash drive is not ready.
USB Memory Full! The USB ash drive has no free capacity.
Can’t Reset. An error occurred during factory reset.
FORMAT USB Mem Error! An error occurred when formatting the USB ash drive.
No Data. USER PATTERN EXPORT: There is no data to export.
SMF Make Error.
USER PATTERN EXPORT: An error occurred during SMF
conversion.
Buer Full nnn
A control buer overowed.
nnn = 000: Controller control buer
nnn = 001: Parameter control buer
nnn = 002: Panel CPU message reception buer
nnn = 003: User interface control buer
nnn = 004: MIDI System Exclusive transmission control buer