Roland JUNO-X - Specifying the Key Range (KEY RANGE SETTINGS); Playing Only the MODEL BANK Tones (SINGLE SETUP); Editing the System Settings (System); Convenient Functions (UTILITY)

43
Settings for the Entire Unit
Specifying the Key Range (KEY RANGE SETTINGS)
You can specify the key range to restrict a sound that you play or an
arpeggio performance to a specic region on the keyboard.
Ø “Specifying the Key Range” (p. 16)
Playing Only the MODEL BANK Tones
(SINGLE SETUP)
When SINGLE SETUP is executed, only part 1 is enabled, and you can
perform with the tones of only one model.
1. Press the [MENU] (WRITE) button.
2. Use the [ÇSELECTÉ] knob to select “SINGLE SETUP,”
and then press the [ENTER] (INIT) button.
A conrmation message for executing SINGLE SETUP is shown.
MEMO
You can jump to the conrmation message for executing
SINGLE SETUP by holding down the [SHIFT] button and
pressing the [MODEL BANK] button.
3. Press the [ENTER] (INIT) button to execute SINGLE
SETUP.
* When SINGLE SETUP is executed, the scene data you were editing is lost.
If you want to keep the data, save the scene before switching to SINGLE
mode.
Ø “Saving the Scene Settings (SCENE WRITE)” (p. 24)
* The SINGLE SETUP state is canceled when you switch scenes.
* The parameters that work with the controllers on this instrument such
as the buttons and knobs dier with each model. See “Correspondence
Between Controllers and Parameters” (p. 27) for more information.
Editing the System Settings (System)
1. Press the [MENU] (WRITE) button.
2. Use the [ÇSELECTÉ] knob to select “SYSTEM,” and
then press the [ENTER] (INIT) button.
3. Use the [Í] [Ë] buttons to select the page that you
want to edit.
SYSTEM
Make basic device settings for the JUNO-X.
Ø “Parameter Guide” (PDF)
SYSTEM EFFECT: Dly
Choose whether the delay eect settings are xed at the
system settings, or are specied by each scene.
If “Source” is set to “SCENE,” use the scene eect parameters to
edit the eect.
Ø “Editing a Scene (SCENE EDIT)” (p. 22)
SYSTEM EFFECT: Rev
Choose whether the reverb eect settings are xed at the
system settings, or are specied by each scene.
If “Source” is set to “SCENE,” use the scene eect parameters to
edit the eect.
Ø “Editing a Scene (SCENE EDIT)” (p. 22)
SYSTEM EFFECT: Cho
Choose whether the chorus eect settings are xed at the
system settings, or are specied by each scene.
If “Source” is set to “SCENE,” use the scene eect parameters to
edit the eect.
Ø “Editing a Scene (SCENE EDIT)” (p. 22)
SYSTEM EQ / COMP
Edit the equalizer and compressor settings.
SYSTEM COLOR SET
Specify the color that is assigned to the buttons.
Ø “Parameter Guide” (PDF)
4. Use the [ÇSELECTÉ] knob to select the parameter,
and use the [- VALUE +] knob to change the value.
For details, refer to “Parameter Guide” (PDF).
5. To save the settings, hold down the [SHIFT] button
and press the [MENU] (WRITE) button.
A conrmation message appears.
If you decide to cancel, press the [EXIT] button.
6. To execute, press the [ENTER] (INIT) button.
Convenient Functions (UTILITY)
Execute convenient functions.
Ø “Convenient Functions (UTILITY Screen)” (p. 45)
Viewing the Software Version (INFORMATION)
View the software version.