13
Getting Ready
Placing the RD-300NX on a Stand
If you place the RD-300NX on a stand, you must use the KS-G8 (sold separately). When placing the RD-300NX on the KS-G8, place it in the position
shown below.
NOTE
Using the RD-300NX with any other stand may produce an unstable situation, possibly causing the instrument to fall or overturn, and resulting in
injury or damage.
For details on how to assemble the stand, refer to the owner’s manual that accompanied the stand.
Align the rubber pads of the stand with the
rear edge of the RD-300NX.
Seen from the rear
Place the RD-300NX so that it does not rest
on the screws located beside its rubber feet.
Seen from the bottom
NOTE
When placing the RD-300NX on the stand, be careful not to pinch your ngers between the instrument and the stand.
To Next Page
Loading...
