Roland RD-300NX

85
Appendices
List of Messages
Error Messages
Indication Situation Action
Error 1
You can only read the music le.
You can only read the music le.
It can not be saved.
–
Error 2
An error occurred during writing.
An error occurred during writing.
The external media’s protect tab may be in the
“Protect” (writing prohibited) position, or the
external media may not yet be initialized.
–
Error 10
No storage media is inserted.
No external media is inserted. Insert the external media and try again.
Error 11
Insucient free memory at the save
destination.
There is not sucient free memory in the save
destination.
Either use dierent external media, or delete
unneeded les before you try the operation
again.
Error 14
An error occurred during reading
An error occurred during reading.
The external media may be corrupted.
Insert other external media and try again.
Alternatively, you can initialize the external
media.
Error 15
The data format is not compatible with this
instrument.
The le is unreadable. The data format is not
compatible with the RD-300NX.
Only les in the following formats can be used.
• Live Set les with an extension of “RDS” (*)
• SMF music les with an extension of “MID”
• Audio les with an extension of “WAV”
For details on audio le formats, refer to “Types
of audio les that the RD-300NX can play” (p. 86).
Error 16
Data could not be read fast enough for
playback of the song.
Data was not called up in time for playback of
the song.
You may be able to play the song after waiting
a few seconds.
Error 18
The audio data format is not compatible with
this instrument.
This audio format is not supported.
Please use 44.1 kHz 16-bit linear WAV format
audio les.
Error 30
The internal memory capacity of the
RD-300NX is full.
The internal memory capacity of the RD-300NX
is full.
–
Error 40
The instrument can’t deal with the excessive
MIDI data.
The RD-300NX cannot deal with the excessive
MIDI data sent from the external MIDI device.
Reduce the amount of MIDI data sent to the
RD-300NX.
Error 41
A MIDI cable has been disconnected.
A MIDI cable has been disconnected. Connect it properly and securely.
Error 43
A MIDI transmission error has occurred.
A MIDI transmission error has occurred.
Check the MIDI cable and connected MIDI
device.
Error 51
System error. Repeat procedure, or power o,
then on.
There may be a problem with the system.
Repeat the procedure from the beginning. If it
is not solved after you have tried several times,
contact the Roland service center.
Error 65
The USB Memory port was subjected to
excessive current.
The USB MEMORY connector was subjected to
excessive current.
Make sure that there is no problem with the
external media, then turn the power o, then
on again.
(*) The RD-300NX cannot read the setup les or live set les of other models.