Roland RD-300NX

42
Making Detailed Settings for the Piano Tones
You can make detailed settings to adjust the piano sound that’s used when you press the [PIANO] button (p. 26).
These detailed settings can be saved for each variation.
1. In the ONE TOUCH PIANO screen, use [DEC] [INC] to select the variation that you want to edit.
2. Press the [TONE EDIT] button.
The TONE EDIT screen will appear.
3. Press the Cursor [ ] [ ] buttons to switch screens, and press the Cursor [ ] [ ] buttons
to move the cursor to the parameter to be set.
Move the cursor to one of the following menus and press the [ENTER] button, then select the parameter you
want to set in the screen that follows.
1. Key Touch Edit
2. Micro Tune Edit
3. Sym. Resonance
4. Write
5. Initialize
4. Use the [DEC] [INC] buttons to edit the value.
For details on the parameters, refer to the Piano Parameters table (p. 43).
5. When you nish making settings, press the [EXIT/SHIFT] button.
You are returned to the ONE TOUCH PIANO screen.
NOTE
Depending on the piano tone selected, this setting may not be available.
Saving the Settings
1. Press the [TONE EDIT] button.
The TONE EDIT screen will appear.
2. Use the Cursor [ ] button to access the last page of the screen.
3. Use the Cursor [
] [ ] buttons to move the cursor to “4. Write,” and press the [ENTER] button.
The conrmation message appears.
Press the [ENTER] button to save the settings. If you want to cancel, press the [EXIT/SHIFT] button.
4. Press the [ENTER] button.
The settings will be saved.
NOTE
Never switch o the power while “Executing...” appears in the display.
Making Detailed Settings for the ONE TOUCH Tones