Roland VersaCamm SP-300V User Manual

Chapter 6 Specifications
115
6-3 About the Blade
The cutting conditions and the service life of the blade change according to the media and the operating environment,
even when using identical blades. The service life also differs according to the type of blade. A rough guide is shown
below.
When uncut areas remain even when the blade force is increased to a value that is higher by 50 to 60 gf than the
values shown in this chart, then replace the blade.
➢The values for "Life of a blade" are estimates for when cutting media of identical type.
Blade
ZEC-U1005
ZEC-U5025
Media
General Signage Vinyl
General Signage Vinyl
Fluorescent Vinyl
Reflective Vinyl
Tool-force
50 to 150 gf
30 to 100 gf
120 to 200 gf
100 to 200 gf
Amount of cutter offset
0.25 mm
0.25 mm
0.25 mm
0.25 mm
Life of a blade*
(General guide)
8000 m
4000 m
4000 m
4000 m

Roland VersaCamm SP-300V Specifications

General

Resolution	Up to 1440 dpi
Connectivity	USB
Print Technology	Piezoelectric Inkjet
Media Handling	Roll-fed
Ink Colors	Cyan, Magenta, Yellow, Black
Media Thickness	Max. 1.0 mm (39 mil) with liner
Media Types	Vinyl, banner, paper, film
Power Requirements	AC 100 to 120 V ±10 %, 50/60 Hz
Operating Environment	Temperature: 20-32°C, Humidity: 35-80% (non-condensing)