77
4-5 Changing How the Printer Operates
Chapter 4 Feature Reference
Description
When you're performing cutting only, it may be convenient to set this feature to "ENABLE." This feeds out media
according to the size of the data sent from the computer before performing cutting. This makes it unnecessary to turn
the media flanges by hand to feed out media every time you perform cutting. Note, however, that this feeds out media
even when you're performing printing only, so set it to "DISABLE" when not needed.
When [PREFEED] is set to "ENABLE," set [EDGE DETECTION] to "ENABLE."
☞ p 70 "Using Transparent Media"
Default Setting
[PREFEED] : DISABLE
Changing the Menu Language and the Units of Measurement
Procedure
➊
Hold down and switch on the sub power.
Use
to select the display (menu) language.
➋
Press .
Use
to select the measurement unit for length.
➌
Press .
Use
to select to the measurement unit for tempera-
ture.
Press
.
Description
This sets the language and units of measurement displayed on the printer's screen.
Default Setting
[LANGUAGE] : ENGLISH
[LENGTH UNIT] : mm
[TEMP. UNIT] : °C
MENU LANGUAGE
ENGLISH
LENGTH UNIT
mm INCH
TEMP UNIT
˚C ˚F
To Next Page
Loading...
Need help?
General
