This secon describes the error messages that may appear on the machine's display, and how to take acon to
remedy the problem. If the acon described here does not correct the problem or if an error message not descri-
bed here appears, contact your authorized Roland DG Corporaon dealer.
AREA TOO SMALL CONTINUE?
The size of the data is larger than the print area of the loaded object to be printed on.
To connue prinng without correcng this, press [ENTER]. The poron extending beyond the print area will not
be printed. To stop prinng, stop sending data from the computer and hold down [SETUP] for one second or lon-
ger. Make the print area wider by replacing the object to be printed on with a larger object or by changing the
posion of the object, then send the data again.
PRINT AREA TOO SMALL
The size of the test print is larger than the print area of the loaded object to be printed on.
Press any key on the operaon panel to go back to the main menu. Make the print area wider by replacing the
object to be printed on with a larger object or by changing the posion of the object, then redo the test prinng.
CANCELED FOR TABLE HEIGHT
The object to be printed on was detected in a posion (at a height) at which it hits the print heads.
Press any key (except the sub power switch) on the operaon panel, and the message disappears. If the setup of
the object to be printed on is completed, the setup is canceled. Redo the setup.
RELATED LINKS
・ P. 57 "Step 2: Start Prinng"
・ P. 73 "Adjusng the Height"
CHECK TABLE HEIGHT
The object to be printed on was detected in a posion (at a height) at which it hits the print heads.
Remove the object to be printed on (remove the cause of the failure) or change its posion. Aer verifying the
message, press [ENTER].
RELATED LINKS
・ P. 73 "Adjusng the Height"
CHECK HEIGHT OF HEAD REFRESHER
The possibility of the print heads colliding into the head refresher (or other obstacles) when they move for head
refreshing was detected.
Press [ENTER] to clear the message.
The jig may be in the way or it may not have been aached correctly. Correctly reaach the head refresher by
removing the jig or reviewing how the jig is aached. Then, perform head refreshing again.
RELATED LINKS
・ P. 167 "Head Refreshing Method"
ADJUST FAILED
When detecng the installaon height of the head refresher, the head gap sensor could not detect the head
refresher posion.
Error Messages
248 3. Messages on the Operation Panel
To Next Page
Loading...
Need help?
General
