RB48 BROOM
ROSCO - A LeeBoy Company
Maintenance
4.6
MAINTENANCE
C. Keep the top of the battery clean. When
necessary, wash with a baking soda solution (1
part baking soda to 4 parts water) and rinse with
fresh water. DO NOT allow the soda solution to
enter the battery cells.
D. Inspect the cables, clamps and hold-down
bracket regularly. Clean and apply a light coating
of grease when needed. Replace corroded or
damaged parts.
CAUTION: Always disconnect the battery
ground (-) cable first. Always reconnect the
positive (+) battery cable first when
servicing battery cables and when
removing or replacing the battery.
Remove the battery ground (-)
cable when welding on the
machine.
E. Check the electrical charging system if the
battery becomes discharged repeatedly. If the
engine is difficult to start or the battery seems
weak, clean and check the terminal connections.
If the problem continues, the battery should be
tested using a battery tester for voltage and
current draw.
WARNING: Explosive gas may remain in and
around the battery for several
hours after charging. Sparks or
flame can ignite this gas causing
an explosion which could shatter
the battery and cause serious
personal injury. Always shut off the
battery charger before disconnecting cables from
the battery terminals.
CAUTION: Always wear eye
protection when servicing batteries.
Caustic solutions can cause serious
eye injuries.
F. If the broom is to be stored for more than
30 days, remove the battery from the broom and
store it in a cool, dry place. During storage, keep
the battery fully charged and check the level of the
electrolyte regularly.
Engine Belts
A. Check the diesel engine belt(s) for
excessive wear, fraying and cracking every 250
service hours. Auxilliary V-belt drives should be
inspected every 100 hours.
B. Adjust engine belt(s) as required to provide
proper tension. Consult the diesel engine
manufacturer's manual for correct tensioning
instructions and specifications.
C. Your ROSCO Broom may be equipped
with an air conditioner with a V-belt drive. For
proper operation, it is important to keep this belt
tensioned properly.
DANGER: Always shut down
engine before adjusting belts.
Severe injury can result if belts are
adjusted on a running engine.
D. When installing new belts, always shorten
the distance between pulley centers so the belt
can be installed without force. Never roll the belt
over a pulley and never pry it with a tool such as a
screw driver. This will damage belts and cause
early failure.
CAUTION: Keep belt guards in
place at all times. Severe personal
injury may result from contact with
turning belts and pulleys.
To Next Page
Loading...