5–10 • Operation NK Series User Guide (1.0)
ability to lock the panel. The panel lock function is reflected in the control panel’s Device Properties page of the
NK-IPS, and can be locked or unlocked as required both from the NK-IPS or from the panel itself.
The PANEL LOCK key and the PROTECT key’s panel lock function are interchangeable. If both function keys are
configured on the one panel, a panel lock can be activated from one key, and deactivated from the other.
A PANEL LOCK key is not available on the factory default configuration. For configuration and functionality of
the PANEL LOCK key, the NK-IPS is required. A PANEL LOCK key can also be configured on the NK1 panel via
Function Key Program Mode.
Linked RCP-NK1 Panel Operation
Overview
When panels are linked together, key behavior remains as above (with single panel system), although the following
details must be noted when linking panels:
• Pressing CHOP will alternate between two sources, including cases when the sources are on different physical
panels.
• Pressing TAKE will activate a take, including cases when the SOURCE key is on a different panel to the TAKE
key.
• If any linked panel has a TAKE key, the linked device enters take mode when a source or crosspoint key is
pressed.
• Locking one physical panel from the control panel’s Device Properties page will also lock all linked panels. The
NK-IPS can be used to unlock panels if required.
• Entering macro record mode causes all linked panels to be in macro record mode, switch events and protects can
be added from different physical panels.
• Macros cannot be appended or added across panels.
• Page SHIFT keys control source and destination pages for the whole linked panel.
• DESTINATION keys control the destination for the whole panel.
• LEVEL and BREAKAWAY keys control the level mask for the whole panel. Breakaway preview is not available
across linked panels.
• If a panel is added to an operating linked panel, the linked panel changes its states in regards to TAKE, PANEL
LOCK and cutbus accordingly.
• If a linked panel is added to an operating linked device that is in TAKE, CHOP, PANEL LOCK, or macro
recording mode, it starts in that mode.
• Menus do not work across linked panels.
NK-A64 Control Layer
Overview
The Analog Audio level of NK-64 routers offers unparalleled configuration and audio processing, allowing users to
mix left and right audio channels to suit their broadcast requirements. Channels may be swapped, phase inverted or
converted to mono (both channels left, both channels right, both channels average, sum and difference).
Pressing the PANEL LOCK key will lock the panel. Pressing the key
again will unlock the panel.
Pan Lock
To Next Page
Loading...
