Programming the AC-Q74
AC-Q74 Installation and Programming Manual 25
In addition:
Wrong entries may reset the controller back to Normal mode.
While in Programming mode, if no key is pressed for 1 minute,
the AC-Q74 exits Programming mode and returns to Normal
mode.
A short press on key may also return the system to Normal mode
in certain Programming modes.
11.3 Changing Lock Strike Code 1
The Lock Strike code 1 is mainly used as a method to quickly test the
Lock Strike Relay during installation.
The default factory setting for the Lock Strike Code 1 is 2580. When
the first user is added to the controller, the default Lock Strike Code 1
is automatically be deleted and the system is ready for a new Lock
Strike Code 1 to be re-entered.
To change Lock Strike Code 1:
1. Enter Programming mode.
2. Press “1” to enter Menu 1.
The Mode LED turns red.
3. Enter the new 4-digit code you wish to set
as Lock Strike Code 1.
The system returns to Normal mode.
You hear three beeps.
The Door LED turns off.
The Mode LED turns green.
• Lock Strike Code 1 does not function in Secure mode.
• Wrong entries return the controller to Normal mode.
• Code 0000 erases the Lock Strike Code 1.
To Next Page
Loading...
Need help?
General
