INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 23 of 57
• Measuring procedure of electronic RUN-OUT with
the distance-diameter caliper arm.
The electronic RUN-OUT measuring device is useful
to check if the rim has some imperfections.
To access the screen to choose the rim control mode,
proceed as follows:
- from the "Home" page, press the button
(Fig. 28 re. 1) and then the button (see
Fig. 29 ref. 1).
1
Fig. 28
Fig. 29
1
- The following screen page will appear on the monitor:
KEY
1 – Return to previous page
2 – Graph deleting button
3 – Wheel spin push button
1 2 3
Fig. 30
Place the distance-diameter caliper grippers (Fig. 31
ref. 1) on the inner side of the rim, as shown in
Fig._31.
Press the green button on the monitor
(Fig. 30 ref. 5) to start the rim analysis procedure.
The circle starts to spin at low speed (30 rpm) and
at the end of the measurement the roundness graph
appears, as shown in the Fig._32.
1
Fig. 31
1297-M008-8
To Next Page
Loading...