Operator`s Manual RM1
Seite/page 99/132 ROTAX KART RM1 Ausgabe/Edition 01/2006
4.7. Exchange and charging of battery
4.7.1. Removal and installation of battery
If you intend to use the vehicle longer than 5 hours, without being able to recharge the battery, or
when the battery has reached the end of its lifetime or is defective, the battery must be exchanged.
Attention: Always replace the battery by an original battery YUASA 12V-6,5 Ah, as this battery
is a matched system with the recharger.
Note: Batteries contain environmentally harmful but at the same time valuable raw
materials and therefore must be appropriately disposed of or recycled.
Removal of battery:
¨ Lift vehicle or place it on a trolley.
¨ Detach the black (-) pole (to avoid short-
circuit).
¨ Remove inner and outer rubber fixation strap
(pos. 19).
¨ Lift battery cover top and bottom part (pos. 20
and pos. 18) together.
¨ Detach red (+) pole.
¨ Remove battery (pos.17) from its support (pos.14).
Attention: By no means a short circuit must be produced between the two connecting pole.
This would damage the battery or even make the battery explode.
Attention: When transporting a removed battery, cover the two poles in case of contact with
metallic objects as this could be a fire risk.
Installation of battery:
¨ Lift vehicle or place it on a trolley.
¨ Install battery with black pole (-) pole being in front/bottom position.
¨ Connect red (+) pole.
¨ Fit battery cover lower and upper part (pos.18 and pos.20) together.
¨ Attach rubber fixation strap (pos.19) attach the fixation strap to the outside first.
¨ Stretch inner rubber fixation strap (pos.19) with right hand, hold it with left hand and hook it
in with the left index finger.
¨ Attach black (-) pole.
To Next Page
Loading...