Installation & Maintenance Instructions
2
Contents
THIS MANUAL CONTAINS IMPORTANT SAFETY
INFORMATION. PLEASE ENSURE IT IS THOROUGHLY
READ AND UNDERSTOOD BEFORE INSTALLING,
OPERATING OR MAINTAINING THE EQUIPMENT.
DUE TO WIDE VARIATIONS IN THE TERMINAL
NUMBERING OF ACTUATOR PRODUCTS, ACTUAL
WIRING OF THIS DEVICE SHOULD FOLLOW THE PRINT
SUPPLIED WITH THE UNIT.
1.0 Introduction 3
2.0 General Information 4
2.1 Introduction 4
2.2 Enclosure Materials 4
2.3 General Actuator Description 5
2.4 Receiving / Inspection 6
2.5 Storage 6
2.6 Equipment Return 6
2.7 Abbreviations used in this Manual 6
2.8 Warranty Information 6
2.9 Identification Label 6
3.0 Approvals 7
3.1 Non-Hazardous Area Enclosures 7
3.2 Hazardous Area Enclosures 7
3.3 Environmental Conditions 8
3.4 Special Conditions For Safe Use
(FMC, ATEX & IECEx approved actuators) 8
3.5 Certification Numbers 8
3.6 Safety Warnings 8
4.0 Health & Safety 9
5.0 Actuator Identification 10
5.1 Outside the Actuator 10
5.2 Inside the Actuator 11
6.0 Installation 13
6.1 Installing your Actuator 13
6.2 Mounting the Actuator 14
6.3 Electrical Installation 17
7.0 Basic Setup 20
7.1 Basic Setup 20
7.2 Basic Menu Structure 21
7.3 Basic Setup Flowchart 21
7.4 Select Local Operation 22
7.5 Set Output Thrust 23
7.6 Select Action at End of Travel 25
7.7 Set Closed Limit of Travel 27
7.8 Set Open Limit of Travel 28
7.9 Calibrate Command Signal Zero Setpoint 29
7.10 Set Deadband 32
7.11 Completing Basic Setup 33
7.12 Menu Structure 34
8.0 Status Alarm Menu 35
8.1 Status Indication 35
9.0 Fault History Menu 37
9.1 Fault History 37
10.0 Default Menu 39
10.1 Default Menus 39
10.2 Parameter Default Values 40
11.0 Advanced Menu 42
11.1 Advanced Menu Access 42
11.2 Advanced Menu 43
12.0 Maintenance 51
13.0 Disposal / Recycling 51
2809
A4US
US
A4
US A4
US
A4
A4 US
US
A4
US
A4
A4 US
To Next Page
Loading...
Need help?
General
