Keeping the World Flowing
3
Rotork designs, manufactures, and tests
its products to meet many national and
international standards. For these products to
operate within their normal specifications, they
must be properly installed and maintained.
This manual is for use with CML-1500 and CML-3000
actuators only. For installation and maintenance instructions
of other CMA actuators, please refer to PUB094-009.
The following instructions must be followed and integrated
with your safety program when installing and using Rotork
products:
•
Read and save all instructions prior to installing, operating
and servicing this product
•
If you don’t understand any of the instructions, contact
Rotork for clarification
•
Follow all warnings, cautions and instructions marked on,
and supplied with, the product
•
Inform and educate personnel in the proper installation,
operation and maintenance of the product
•
Install equipment as specified in Rotork installation
instructions and per applicable local and national codes.
Connect all products to the proper electrical sources
•
To ensure proper performance, use qualified personnel to
install, operate, update and maintain the unit
•
When replacement parts are required, ensure that the
qualified service technician uses replacement parts
specified by Rotork. Substitutions may result in fire,
electrical shock, other hazards, or improper equipment
operation
•
Keep all product protective covers in place (except when
installing, or when maintenance is being performed by
qualified personnel), to prevent electrical shock, personal
injury or actuator damage
•
Operation of actuator in an inappropriate fashion may
cause harm or damage to unit or other equipment
surroundings
1.0 Introduction
A4US
US
A4
US A4
US
A4
A4 US
US
A4
US
A4
A4 US
To Next Page
Loading...
Need help?
General
