Keeping the World Flowing
51
12.0 Maintenance
Routine maintenance should include the following:
•
Check actuator to valve fixings bolts for tightness
•
Ensure valve stems and drive shafts are clean and
properly lubricated
•
If the motorized valve is rarely operated, a schedule of
operation should be set up and adhered too
•
Check the actuator for damage, loose or missing fixings
•
Ensure that there is not an excessive build up of dust or
contaminate on the actuator
13.0 Disposal / Recycling
User advice on disposal of your product at the end of its life.
Please refer to table below. In all cases check local authority
regulations before disposal.
Subject Definition Remarks / examples Hazardous Recycleable
EU Waste
Code
Disposal
Electrical &
Electronic
Equipment
Printed circuit boards All products Yes Yes 16 02 14
Use specialist recyclersWire All Products No Yes 16 02 16
Glass Lens/Window CMA No Yes 20 01 02
Metals
Aluminium Brackets/housings No Yes 20 01 40
Use specialist
metalrecyclers
Copper/Brass Wire, motor windings/PCBAs No Yes 20 01 40
Zinc N/A No Yes 20 01 40
Iron/Steel Gears and shafts No Yes 20 01 40
Mixed Metals Bushings No Yes 20 01 40
Plastics
Glass-filled nylon Electronic chassis No Yes 07 02 13
Disposal as general
commercial waste
Unfilled Gears and bearings No Yes 07 02 13
Window Sealant Silicone Window adhesive Yes No 08 04 09
Will require special
treatment before disposal.
Use specialist recyclers or
waste disposal companies
Adhesive Anaerobic Sealant Thread locker Yes No 08 04 09
Grease Grease Gears and ball screws Yes No 13 02 08
Rubber Seals & O-rings Cover and shaft sealing No No 07 02 99
May require special
treatment before disposal.
Use specialist waste disposal
companies
Fig 13.6 CMA Disposal recycle chart
A4 US
US
A4
US
A4
A4 US
To Next Page
Loading...
Need help?
General
