ROTOTILT ICS - System Information and Feeder Function; System information; Double feeder

© Rototilt Group AB 2018-03-16
Serial number 000655360
Program version, Cabin Rototilt
11.222.333
Program version, Display Rototilt
11.222.333
Program version, Tiltrotator 01.002.003
Supply voltage Cab 0.0V
Tiltrotator 0.0V
Time 12:42
Date 2016-10-01
Hours counters
Power on 0:08
Rotor 0:00
Tilt 0:00
Grapple 0:00
Extra2 0:00
English
EN
Double feeder
The Double feeder mode can be
activated after Rototilt® has been
disengaged.
The function is either controlled with
roller B, or with switches 1 and 2.
Activate control with the switch via the
Angles menu.
”On/off Double Feeder” must be
conrmed with OK.
The function is only active in this view.
See Operation of extra hydraulics.
System Information
Serial number - The tiltrotator’s specic
number, also found on the rating plate.
Software version - Shows the version
number for the software of each unit,
display, CCI and TCU.
Supply Voltage - Power supply to the
control unit and tiltrotator.
Time - Current time. Select the row and
then press the middle function button
(green) to set the time.
In some cases Bat Clock is not
connected, which results in the system
losing the time and date setting.
Date - Current date.
Hours counters - Shows the total hours
of operation for the tiltrotator, and the
total hours of operation for each function.
2200230_ _7225