RTX RTX725 Series - Physical Buttons; LED Overview; LED Patterns; LED Indication

Page 15 of 52
4.3 Physical buttons
The headset is operated using the buttons on the earcup with boom arm. The ANC button is located on the
opposite earcup, as ANC is not available for Mono headsets (Fig.8)
The following table represents the functions of the buttons seen on the figures above
INPUT
FUNCTIONS
POWER SLIDER
Power the headset on and off
SCROLL WHEEL WITH AN
INTEGRATED KEY
Increase volume
Decrease volume
MULTI-FUNCTION BUTTON
Answer call
End call
Reject call
Trigger AI voice assistant
Microsoft Teams button
Hold/Swap/Retrieve Call
Leave conference during call
MUTE KEY
Toggle mute
Play/Pause music
Skip to next track (double click)
Announce battery level (press and hold)
DECT KEY
Enter DECT pairing mode
Reset settings (press and hold)
De-register 2
nd
headset during Idle
BT KEY
Toggle Bluetooth
Enter Bluetooth pairing mode
ANC KEY
Toggle ANC
For more details on the RTX725X headset controls refer to 8.1. Controls.
4.4 LED overview
The headset has a single tricolor LED on the tip of the boom-arm, which is a combination of 3 LEDs – red,
green, and blue. All visual indications are disabled if “eco mode” is enabled.
4.4.1 LED patterns
The LED supports 3 different kinds of patterns. The definitions of each pattern can be seen in the table below:
LED PATTERN
DEFINITION
BLINK
ON-OFF
BREATHING
One color that slowly becomes brighter until it reaches full brightness and
then dimmers until fully dimmed. It is a repeated cycle.
ALTERNATING
Alternating between two colors
4.4.2 LED indication
The table below presents the LED indication depending on the status of the headset.
FUNCTION
STATUS LED COLOR PATTERN
SYSTEM
Reset setting started
White
Blink 3 times