Page 25 of 52
"Call accepted. Call on hold" and put the first call on hold. If there is a secondary headset registered to the
same base/dongle and participating in the first call, it will follow with the primary headset to the second
incoming call. User can swap the two calls (from primary headset) by pressing the Multi -Function Button,
which will be followed by the voice prompt “Call swapped”.
Long pressing the Multi-Function Button will end the first call and accept the second. That will be followed
by the announcement “Call retrieved”.
User can reject the secondary call by double pressing the Multi-Function button.
NOTE: In case of two calls established via BT and USB-DECT link refer to Chapter 16 Appendix D.
8.1.3 Microsoft Teams integration
The Multi-Function button has integrated functionalities to respond to Microsoft Teams upon long pressing
it at Idle state.
Depending on the scenario long pressing the MS Teams button will trigger activating different actions in
Teams:
• When there is no notification from Teams present long pressing the multi-function button will bring
MS Teams on the foreground.
• If there is a missed call notification, long pressing the multi-function button will open MS Teams
missed calls list
• In case of voicemail notification, the button will open the MS Teams voicemail list
• If there is a meeting alert present, it will open the MS Teams meeting.
Additionally, the LED on the microphone also reacts with a purple blink upon notifications, missed call,
voicemail, or meeting alert in MS Teams.
If the headset comes out of range during a MS Teams meeting, the base will put the call on hold automatically.
It will also automatically resume the call when the headset is available again.
8.1.4 Terminating call
To end an active call from the headset, the user has to simply press the multi-function button or place the
headset in cradle onto the RTX745x base station.
To Next Page
Loading...
