Page 33 of 52
9.4.7 Reset User Setting
This menu item allows the user to clear all configurations to their initial values. When chosen the user can
either confirm and reset all user settings or with the help of the Scroll Wheel Key - cancel. If there is a
headset registered to the base, it will send the command further to the headset and reset all user settings
for the headset as well.
9.4.8 Factory Reset
Allows the user to perform factory reset and return the base to its initial state and clear the cache memory.
If there is a headset registered to the base it will send the command further to the headset and perform
factory reset for it too.
NOTE: Reset user settings returns all configurations to their initial state. That is also what happens when we
perform Factory reset, but Factory reset will delete all current registrations as well.
Fig.24 Factory Reset
9.5 Call activity on base
To have call activity on the base, a master headset must be registered and locked to the base. If the master
headset loses connection during call activity, all the calls will be terminated.
9.6 Incoming call
The base will notify the user with visible and audible indication whether an incoming call is from EHS or USB
line (Fig.25). If both lines are in idle state and an incoming call is received to one of the lines, the base
rings and displays the call. However, if there are two simultaneous incoming calls from two different lines,
the active control is made by the first incoming call (the first that came is served first). The second incoming
call cannot be accepted by the base until the first incoming call has been answered or ended, or the line is
swapped manually by the user. This means that in case of having one of the lines occupied (in active call), the
new incoming call will be displayed as waiting in a queue.
To Next Page
Loading...
