Page 46 of 52
Step 7 Enter the Access code (AC)
NOTE: By default, the AC is 0000. You can change the AC code on the VoIP base (See step 4)
Step 8 The headset base will start the registration process. After a while, it will be registered to the
VoIP system.
14.2 Register RTX725x headsets.
The registration of the RTX725x headsets to the VoIP system is done via the Extensions page. The procedure
is the same as registering an RTX handset. Therefore, please refer to the VoIP System guide and follow the
steps for enabling registration mode for the VoIP bases. As soon as you have enabled it, follow the steps
below to register the headset.
IMPORTANT: Due to technical limitations, the RTX725x headsets must be free of RTX745x registration before
registering to the VoIP system. This means that the headsets must not be present on the RTX745x base when
registering to the VoIP system.
NOTE: If a headset is registered to the VoIP system and at the same time you register it to an RTX745x base,
the connection to the RTX745x will not be stable enough. Therefore, if you wish to have a headset registered
both to the VoIP system and to the RTX745x base, we recommend registering the RTX745x to the VoIP system
(refer to 13.1 Register RTX745x headset base). By doing so, the headset will both support the DECT and other
networks.
NOTE: When using the headset in standalone mode in the VoIP system, it is recommended to charge the
device via the USB-C cable attached to an adaptor. Else, if connected to the RTX745x base or to a PC, the
headset connection might not be stable enough.
Step 1 Power on the headset via the power slider
Step 2 Activate the DECT registration on the headset by long pressing the DECT button on the
headset until the voice prompt announces “Registering”.
Step 3 After a while, the headset will register to the VoIP base.
To Next Page
Loading...
