Ruby Tech GS-2224L User Manual

50
Parameter description of Port 21 ~ Port 24:
Connector Type:
Display the connector type, for instance, UTP, SC, ST, LC and so
on.
Fiber Type:
Display the fiber mode, for instance, Multi-Mode, Single-Mode.
Tx Central Wavelength:
Display the fiber optical transmitting central wavelength, for
instance, 850nm, 1310nm, 1550nm and so on.
Baud Rate:
Display the maximum baud rate of the fiber module supported, for
instance, 10M, 100M, 1G and so on.
Vendor OUI:
Display the Manufacturer's OUI code which is assigned by IEEE.
Vendor Name:
Display the company name of the module manufacturer.
Vendor P/N:
Display the product name of the naming by module manufacturer.
Vendor Rev (Revision):
Display the module revision.
Vendor SN (Serial Number):
Show the serial number assigned by the manufacturer.
Date Code:
Show the date this SFP module was made.
Temperature:
Show the current temperature of SFP module.
Vcc:
Show the working DC voltage of SFP module.
Mon1(Bias) mA:
Show the Bias current of SFP module.
Mon2(TX PWR):
Show the transmit power of SFP module.
Mon3(RX PWR):
Show the receiver power of SFP module.

Ruby Tech GS-2224L Specifications

General

Brand	Ruby Tech
Model	GS-2224L
Category	Switch
Language	English

Summary

1. Introduction

1-3. Features

Details the hardware and management features of the GS-2224L switch.

2. Installation

2-1-4. Configuring the Management Agent of GS-2224L

Explains how to configure the switch's management interface via RS-232 or Ethernet.

2-1-5. IP Address Assignment

Explains IP address structure, classes, subnet masks, and private IP address blocks.

3. Operation of Web-based Management

3-1-4. IP Configuration

Guides on configuring the switch's IP address, subnet mask, default gateway, and DNS.

3-3. VLAN

Explains VLAN concepts and configuration, supporting Tag-based and Port-based VLANs.

3-8. ACL

Explains Access Control Lists (ACLs) for packet filtering based on various parameters.

3-10. 802.1X Configuration

Explains 802.1X port-based network access control for user authentication.

3-12. STP Configuration

Details Spanning Tree Protocol (STP) configuration for avoiding network loops.

3-20. Diagnostics

Covers device self-diagnostics, including diagnostics, loopback, and ping tests.

4. Operation of CLI Management

4-1-1. Login

Details the process of logging into the switch via the command-line interface (CLI).

4-2. Commands of CLI

Lists and categorizes available CLI commands, including global and local commands.

5. Maintenance

5-1. Resolving No Link Condition

Lists possible causes for a "no link" LED status on switch ports.

Appendix A Technical Specifications

Appendix B Null Modem Cable Specifications