Chapter
3
Periodic
Maintenance
13) Oiling the
air
pump
A WARNING
Mount
the
cover
removed
in
place
after
oiling. Failure
to
follow
this instruction
may
result
in a
serious
injury.
The air pump is inside the door at the feeder section.
Check the oil level once a
week
and be sure that the
oil
in
the oil
cup
is
always full.
[
Recommended
lubrication
list
for
the
pump
and
centralized
oiling ]
system
«NOTICE»
1.
Use the recommended oil. Do not use the used oil
or
oil with special
additives.
2.
The
specific gravity
and
viscosity
of
the oil for the centralized oiling
system
and
pump
is lower than that
of
the
manual
lubrication oil.
When this
oil
is
used
for
the
manual
lubrication, the lubrication
effect will
be
reduced prematurely. Therefore,
only
use this
oil
for
the centralized oiling system
and
pump.
Maker
Oil
Shell
TETRA OIL 32 or 46
Mobil Mobil DTE 24 or
25
ESSO
UNIPOWER MP 32
or
46
(Note) The
recommended
oil is equivalent to
antiwear
type
ISO
(International Organization for Standardization)
VG
32
or
46.
Draining the water in the
air
compressor
Drain the water before turning the
power
OFF.
If
doing
it
after turning the
power
OFF,
the water inside will
not
drain
completely
and
the valve will rust.
Before turning the
power
OFF, loosen the valve to drain the water
in
the
air compressor. When opening the valve, the water that accumulated inside
will drain out along with the air. After draining the water, close the valve
fully.
Maintenance Edition - 33
To Next Page
