Chapter
3 Periodic Maintenance
4)
Cleaning each sensor surface
A WARNING
Push the emergency stop button to stop the press before cleaning. Failure to follow this instruction
may
result in a serious injury.
Paper
feed
~
(4)
Each sensor is positioned as shown in the illustration
on
the left.
(1) Double sheet detector sensor
(2) Paper feed sensor
(3) Blanket
jam
detector sensor
( 4) Cylinder
ON
sensor
(5) Delivery pile lowering sensor
(6) Water sensor
«NOTICE»
If
using cleaning solution
when
cleaning
the
sensor surface, it will damage
the
sensor.
Only
use
a dry soft rag
when
cleaning.
Foreign
particles
and
spray
powder
adhering
on
the
sensor
surface
(1)
through (5) will cause misfunctioning. Wipe
off
the sensor surface with a
dry soft rag and keep it clean.
Maintenance Edition - 29
To Next Page
Loading...
