D. Water rider oscillating roller release knob
This
knob
is
used
to
separate
the
water
rider
oscillating roller from the water form roller and to
contact
it
with the water form roller.
(Operation side, Non operation side)
E. Water form roller release lever
lf2J
position ...
The
water
form
roller
is always
separated
(OFF)
from
the
plate
surface. Set the lever at this position,
when the press will not be used for a
long period.
IE]
position ... The ON/OFF
of
the water form roller
on the plate surface
is
controlled by
the water and ink form roller ON
button and the water and ink form
roller OFF button. When printing, set
the lever at this position.
Chapter 2 Names and Functions
F. Water control wiper
This wiper is used to return the excess dampening
solution to the water fountain to assure a stable
dampening solution supply from the metering roller
to the water oscillating roller.
G.
Dampening solution circulation device
By circulating and filtering the dampening solution,
it
keeps the condition
of
the dampening solution
stable.
Introduction Edition- 37
To Next Page
Loading...
