S-TEC Fifty Five X - Page 29

2-14 3rd Ed. Sep 30, 06
S–TEC
Table 2-2. Pre-Flight Test (continued from page 2-12)
ACTION RESPONSE
35. Move A/C Control Wheel as far
forward as possible.
After 3 seconds, TRIM
∧
annunciation appears on AP display
as shown in Fig. 2-13a, and Elevator
Trim Wheel begins to run nose up
with increasing speed.
After 7 seconds, TRIM
∧
annunciation flashes.
36. Move A/C Control Wheel as far
aft as possible.
After 3 seconds, TRIM
∨
annunciation appears on AP display
as shown in Fig. 2-13b, and Elevator
Trim Wheel begins to run nose down
with increasing speed.
After 7 seconds, TRIM
∨
annunciation flashes.
37. Move A/C Control Wheel forward
until TRIM
∨
is extinguished.
HDG, VS, and +0 annunciations only
appear on AP display.
Note: If autopilot is equipped with a Remote Annunciator, and A/C is equipped
with a Flight Director, then proceed to step 38. Otherwise, proceed to step 50.
38. Set Autopilot Master Switch to
FD position.
Audible Alert sounds a periodic tone.
FD annunciation appears on Remote
Annunciator, along with HDG and VS,
as shown in Fig. 2.14.
39. Move A/C Control Wheel left and
right.
A/C Control Wheel’s increased
freedom of movement indicates that
Roll Servo is disengaged.
40. Move A/C Control Wheel forward
and aft.
A/C Control Wheel’s increased
freedom of movement indicates that
Pitch Servo is disengaged.