S-TEC Fifty Five X - Page 5

iv 3rd Ed. Sep 30, 06
S–TEC
3.2 Precision Approach Procedures.....................................................3–12
3.2.1 Straight-In ILS Approach....................................................3–12
3.2.1.1 Software Revision 5 and Above......................3–12
3.2.1.2 Software Revision 4 and Below......................3–14
3.2.2 ILS Approach with Procedure Turn................................3–15
3.3 Non-Precision Approach Procedures............................................3–15
3.3.1 Straight-In Back Course Approach..................................3–15
3.3.1.1 Pilot Selectable Intercept Angle.......................3–17
3.3.2 Back Course Approach with Procedure Turn...............3–18
3.3.3 Straight-In LOC Approach................................................3–21
3.3.4 Straight-In VOR Approach.................................................3–23
3.3.5 LOC Approach with Procedure Turn..............................3–25
3.3.6 VOR Approach with Procedure Turn..............................3–28
3.3.7 NAV GPSS Approach..........................................................3–31
3.4 Flight Director Operation..................................................................3–31
3.4.1 FD/AP Mode.........................................................................3–31
3.4.2 FD Mode...............................................................................3–32
3.5 Yaw Damper Operation....................................................................3–33
3.5.1 AUTO Mode..........................................................................3–34
3.5.2 ON Mode..............................................................................3–34
3.5.3 Yaw Damper Trim..............................................................3–34
3.6 Autopilot Disconnect ........................................................................3–34
3.7 Automatic Trim Disable....................................................................3–34
4 Operating Parameters..................................................................................4–1
4.1 Roll Axis Limits..................................................................................4–3
4.2 Pitch Axis Limits.................................................................................4–3
5 Glossary...........................................................................................................5–1