2. TECHNICAL DATA ROYAL
Page 2/5 REV.4 SEPT.2003 Saeco International Group
2. Technical data (Royal Digital / Exclusive/ Digital Redesign)
Royal Digital / Exclusive / Digital Redesign
Technical data
Power supply/output:
230V 50Hz 1250W
Safety system:
170°C Safety thermostat for instantaneous water heater
Temperature monitoring:
KTY Temperature sensors transmit respective
temperatures to electronic system
Continuous flow thermoblock:
Instantaneous water heater (1090 W) for coffee and hot
water dispensing
Pump:
Ulka reciprocating piston pump with angle connector
and thermostat - 48 W, 230V, 50 Hz.
Type EX5, 20 l/h
Safety valve:
Conventional safety valve connected to pump
Water filter:
Installed in machine in front of the turbine and pump.
Gearmotor:
Direct current, 30 - 35 V
Cup warmer/gear resistor:
Approx. 437W / 130Ω
Grinder (conical grinder):
Motor:
Plastic grinding screw, galvanised steel grinding cone
and grinding disc
Direct current, 260 V
Second doser:
Coffee dose adjustable by means of lever (6 - 9g) outside
housing
230 V - Magnet coil
Second doser:
Doser for powder coffee, by means of measuring spoon
Power consumption:
During heating - approx. 4.5 A
Standby - Approx. 0.04 A
Pump pressure:
Max. 15 bar
Dimensions W x D x H in mm:
330/385/395 (Digital)
385/450/395(Exclusive)
Weight:
Approx. 15 kg
Capacity of coffee bean container:
Approx. 300g
Capacity of water tank:
Approx. 2.4 l max.
Boiler - Capacity:
Approx. 1.0 ccm, 10 ml volume
De-aeration time:
Approx. 1 - 2 sec. for initial star-up
Heating time:
Approx. 80 sec. with water at 10°C
Re-heating time:
None due to boiler
Steam heating time:
From coffee temperature to 127°C - Approx. 50 sec.
Coffee dispensing temperature:
Approx. 86° C
Grinding time:
Initial grinding with completely empty machine:
Approx. 15 sec. / subsequent grinding: approx. 5.5 sec.
Time to make expresso:
Approx. 28 sec. for 50 ml
Time to make cup of coffee:
Approx. 40 sec. for 100 ml
To Next Page
Loading...
