ROYAL 2. TECHNICAL DATA
Saeco International Group REV.4 SEPT.2003 Page 5/5
5. Technical data (Royal Office)
Royal Office
Technical data
Power supply/output:
230V 50Hz 1500W
Safety system:
170°C Safety thermostat for instantaneous water heater
Temperature monitoring:
KTY Temperature sensors transmit respective
temperatures to electronic system
Continuous flow thermoblock:
Instantaneous water heater (1090 W) for coffee and hot
water dispensing
Pump:
Ulka reciprocating piston pump with angle connector
and thermostat - 48 W, 230V, 50 Hz., Type EX5
20 l/h
Safety valve:
Conventional safety valve connected to pump
Water filter:
Installed in machine in front of the turbine and pump.
Gearmotor:
Direct current, 30 - 35 V
Gear resistor:
Approx. 437W / 130Ω
Grinder (conical grinder):
Motor:
Plastic grinding screw, galvanised steel grinding cone
and grinding disc
260 V Direct current
Second doser:
Coffee dose adjustable by means of lever (6 - 9g) outside
housing
230 V - Magnet coil
Second doser:
No
Power consumption:
During heating - approx. 5.7 A
Standby - Approx. 0.04 A
Pump pressure:
Max. 15 bar
Dimensions W x D x H in mm:
385/450/460
Weight:
Approx. 14 kg
Capacity of coffee bean container:
Approx. 1,000g
Capacity of water tank:
Approx. 6 l max.
Instantaneous water heater capacity:
Approx. 1.0 ccm, 10 ml volume
De-aeration time:
Approx. 1 - 2 sec. for initial star-up
Heating time:
Approx. 90 sec. with water at 10°C
Re-heating time:
None due to boiler
Steam heating time:
From coffee temperature to 127°C - Approx. 50 sec.
Coffee dispensing temperature:
Approx. 86° C
Grinding time:
Initial grinding with completely empty machine:
Approx. 15 sec. / subsequent grinding: approx. 5.5 sec.
Time to make expresso:
Approx. 28 sec. for 50 ml
Time to make cup of coffee:
Approx. 40 sec. for 100 ml
To Next Page
Loading...
