Saeco Classic - Page 94

5. SERVICE PROGRAMME ROYAL
Page 24/24 REV.4 SEPT.2003 Saeco International Group
Function Setting range Increment Comments
GRINDS COUNTER
Number
0-50 +/-1 Counts number of coffee cycles.
When this value reaches the
Grinds Stop value, "GRINDS
CONTAINER EMPTY" will be
displayed. (Reset by removing
dregs drawer for emptying - min.
6 sec.)
GRINDS STOP
30
5-50 +/-1 Number of cycles until "EMPTY
GRINDS CONTAINER" is
displayed.
--TOTAL WATER--
(ml) Number
--------------------- -----------------
------
Total water flow volume (in ml) /
not resettable
WATER DESCALING
(ml) Number
--------------------- -----------------
------
Total water flow (in ml) since last
descaling / resettable
HOT WATER
FLOW (l/h) 20
6 - 34 1/h +/- 2 1/h The pump delivery rate for hot
water can be expressed in litres
per hour.
--HOT WATER---
PUMP ADJUST. 63000
58,000 - 65,500 +/- 1 The pump delivery rate is adjusted
in relation to the HOT WATER
FLOW setting by means of a
phase controlled modulator. Pump
tolerances can thus also be
adjusted. An equivalent value is
saved under HOT WATER PUMP
ADJUSTMENT.
TURBO FACTOR
100
10 - 250 Flow meter conversion factor
MACHINE STATUS
160
0 - 255
--DATE OF MANUF---
DAY
--------------------- -----------------
------
--DATE OF MANUF---
MONTH
--------------------- -----------------
------
--DATE OF MANUF---
YEAR
--------------------- -----------------
------
This date indicates when the
machine was manufactured. This
date cannot be changed.
Exit: Switch the machine off at the main switch.