DOCUMENT SSE-0000077399-01 - VERSION 1.0 - MAY 2010 43
S
AGEM SÉCURITÉ DOCUMENT - REPRODUCTION AND DISCLOSURE PROHIBITED
MORPHOACCESS® J SERIES – User Guide Introduction to authentication with contacless card
ACCESS CONTROL BY
AUTHENTIFICATION
ACCESS CONTROL BY
AUTHENTIFICATION
ACCESS CONTROL BY
AUTHENTIFICATION
ACCESS CONTROL BY
AUTHENTIFICATION
ACCESS CONTROL BY
AUTHENTIFICATION
ACCESS CONTROL BY
AUTHENTIFICATION
1. Introduction to authentication
with contacless card
Selecting the type of contactless card to be supported
On MorphoAccess
®
J Series terminal equipped with a MIFARE
®
/DESFire
®
contactless smartcard reader (see section Scope of the document), the type of
contactless smartcard enabled are defined by the following specific
configuration key:
• 0 means " default mode (MIFARE
®
card only)"
• 1 means " Support of DESFire
®
card only"
• 2 means " Support of MIFARE
®
card only"
• 3 means "Support of both DESFire
®
and MIFARE
®
cards"
It is then necessary to configure the parameters listed in the next sections so as
to set the wished recognition mode using contactless smart card. Note that
when app/contactless/enabled profiles key is set to 0 and the parameters listed
in the following sections are configured so as to set a recognition mode using
contactless smartcard, MIFARE
®
card reading is automatically enabled.
For terminal configured for MIFARE
®
smart card only (see section Scope of
the document), it is only necessary to configure the parameters listed in the next
sections so as to set the wished recognition mode and enable MIFARE
®
card
reading at the same time (i.e. set that key to 0).
Recognition modes
Various recognition modes using contactless card can be applied depending on
the fingerprint templates location (user's contactless card or terminal database)
and the required security level.
Recognition with DESFire
®
cards supposes that the user swipes a DESFire
®
(depending on configuration) card containing some structured data (identifier,
biometric templates...).
Enabled profiles
app/contactless/enabled profiles 0-3
To Next Page
Loading...