10 DOCUMENT SSE-0000077399-01 - VERSION 1.0 - MAY 2010
S
AGEM SÉCURITÉ DOCUMENT - REPRODUCTION AND DISCLOSURE PROHIBITED
Interfaces presentation MORPHOACCESS® J SERIES – User Guide
Power supply interface (see figures 2 • 2 and 2 • 3)
The terminal can be powered by two different ways:
• Either by the two wires +12V DC/GND (11)
• Or by the Power Over Ethernet function
Ethernet interface can be used to power the MorphoAccess
®
J Series terminal
through POE (Power Over Ethernet) mode. According to the POE standard two
modes are available: power on data pins and power on dedicated pins.
On MorphoAccess
®
J Series terminal, POE can be used with RJ45 connector
(9) or with block connector (12). Modes are implemented as follows:
• POE through RJ45 connector (9): on data pins or on dedicated pins.
• POE through block connector (12): on data pins.
Use either one of these modes depending on POE implementation on your local
Ethernet network.
A hardware reset button executes, when pressed, a power down/power up
sequence (14). This reset button is located under the removable smoked front
cover.
Administration interface (see figures 2 • 2 and 2 • 3)
The terminal can be configured through:
• A RJ45 Ethernet connector (LAN 10/100 Mbps), using TCP or SSL
protocol (9)
• A 5 wires Ethernet connection (LAN 10/100 Mbps), using TCP or SSL
protocol (12)
•A Wi-Fi
TM
adaptor plugged in the rear USB host port (10)
• a USB mass storage key for punctual and limited modifications, plugged,
when required, in the front USB port (13). This USB port is located under
the removable smoked front cover.
Access control devices and systems interface (see figure 2 • 2)
The terminal offers several interfaces dedicated to access control systems and
devices:
• the same Ethernet or Wi-Fi
TM
link, as the one used for configuration, using
UDP, TCP, or SSL protocol (9), or (12)
• one serial output port which supports these protocols : Wiegand /
To Next Page
Loading...