Sagem Securite MorphoAccess J-Bio - Bypassing Biometric Control in Authentication

DOCUMENT SSE-0000077399-01 - VERSION 1.0 - MAY 2010 51
S
AGEM SÉCURITÉ DOCUMENT - REPRODUCTION AND DISCLOSURE PROHIBITED
MORPHOACCESS® J SERIES – User Guide Access control by authentication
ACCESS CONTROL BY
AUTHENTIFICATION
ACCESS CONTROL BY
AUTHENTIFICATION
ACCESS CONTROL BY
AUTHENTIFICATION
ACCESS CONTROL BY
AUTHENTIFICATION
ACCESS CONTROL BY
AUTHENTIFICATION
ACCESS CONTROL BY
AUTHENTIFICATION
To enable this mode set app/bio ctrl/authent card mode to 1.
To disable this mode set app/bio ctrl/authent card mode to 0.
Required tags on card
if CARD MODE tag value is ID_ONLY (fingerprint check disabled).
if CARD MODE tag value is PKS (fingerprint check required).
Card structure is described in MorphoAccess
®
Contactless Card Specification.
Bypassing the biometric control in authentication
When this option is activated, only the user ID is required on the user’s card.
This option can be combined with any of the authentication modes. Activating
this option means that the fingerprint check is disabled.
The terminal controls that the user ID exists in the database
When combined with an authentication mode with templates in local database,
the MorphoAccess
®
verifies that the User ID is present in the local database
before granting the access.
Authentication with User ID only on contactless card
ID
Card
Mode
PK1 PK2 PIN BIOPIN
Authen card
mode
(ID_ONLY)
Yes Yes No No No No
ID
Card
Mode
PK1 PK2 PIN BIOPIN
Authen card
mode (PKS)
Yes Yes Yes Yes No No
Disabling biometric control, but User ID must be present in the
local database
app/bio ctrl/bypass authentication 1 (Enabled)
app/bio ctrl/authent ID contactless 1 (Enabled)