SAJ H2 - Prepare Installation Tools

H2 series
26
4.4. Prepare installation tools
The tools illustrations are for your reference. Installation tools include but are not limited to the following
recommended ones. Use other auxiliary tools based on site requirements.
Marker Measuring tape
Utility knife
Multimeter
Measurement
range: 1100 V DC
Wrist strap
Protective gloves Dust mask Earplugs Goggles
Insulated shoes
Vacuum cleaner
Heat shrink tubing
Heat gun
Hammer drill
Drill bit: Φ10
Rubber mallet
Electric screwdriver
Tool bit: M4
Phillips screwdriver
Specification: M4
Wire stripper
Hydraulic plier
Crimping tool
Crimping range: 2.5-6
mm²
Wrenchfor MC4
terminal
Wire clipper RJ45 crimping tool
Flat-blade
screwdriver M2
Torx screwdriver TX30
Socket wrenches
Figure 4.6. Suggested installation tools