28
4.6. Install the inverter
Before you start
Make sure that the wall can bear the weight of the inverter and accessories.
Procedure
Step 1. Use a positioning jig to mark eight holes on the wall according to the following figure. Then, drill
eight holes on the wall.
Alternatively, you can place the mounting plate onto the wall and mark upper six holes and place the
inverter onto the wall to mark the bottom two holes.
Notes:
⚫ Reserve enough distance at the inverter bottom for installing the metal cable conduits.
⚫ The upper six holes are reserved for installing the upper mounting plate while the bottom two
holes are for the bottom locking brackets of the inverter.
To Next Page
Loading...
