VM1000 Series
‐128‐
Figure 7-3 Overcurrent at constant speed (Err04)
Whether there exists a external force
that drives the motor during
acceleration
Whether the acceleration time is
short
Yes
No
No
No
Yes
Yes
Cancel the external force
or install a braking resistor
Adjust the voltage to
normal range
Install the braking unit and
braking resistor.
Overvoltage at acceleration
Whether the input voltage is too high
seek for technical support
Increase the acceleration time
The braking unit and braking resistor
are not installed
Yes
Figure 7-4 Overvoltage at acceleration (Err05)
To Next Page
Loading...
Need help?
General
