VM1000 Series
‐65‐
4.7 Parameters Restore as Factory Value
Before restoring the parameters as factory value, please confirm the recovery does
not pose a safety hazard to the equipment (such as control failure), nor lost some
parameters after the commissioning. If necessary, it should make records. Note:
You can copy the parameters by LCD keypad.
Steps:
(1) Turn on F0 group; enter F0.20 (parameter initialization).
(2) Select 1 is factory parameters restoring (not including the motor parameters and
record values)
(3) Select 2 is recorded value clearance, including a variety of accumulated data
such as running time.
To Next Page
Loading...
