VM1000 Series
‐50‐
3.3 Viewing Methods of Status Parameters
In stop or running status, it can separately demonstrate various status parameters
by using “》”. Whether parameters are displayed is determined by the binary bits of
values converted from the values of F7.03(parameter 1 LED displayed at running),
F7.04(parameter 2 LED displayed at running), and F7.05(parameter 3 LED
displayed at stop) in the hexadecimal format
In stop status, a total of 12 status parameters can be displayed: setting frequency,
bus voltage, DI input status, DO output status, Analog inputAI1 voltage, Analog
inputAI2 voltage, actual count value, actual length value, PLC (running steps),
load speed, PID setting, PULSE input frequency and three reserved parameters.
Pressing “》” to select the parameters.
In running status, there are 29 status parameters: running frequency, setting
frequency, bus voltage, output voltage,output current are default display.Other
display parameters:output power, output torque, DI input status, DO output status,
analog input AI1 voltage, analog input AI2 voltage, analog input AI3
voltage,actual count value, actual length value,linear speed, PID setting, PID
feedback are displayed by the binary bits of values converted from the values of
F7.03, F7.04. Pressing “》”and then switch the keys sequencely to display the
selected parameter.
When VFD is power-on again, the display parameters are defaulted as the selected
parameters before power off.
3.4 Password Setting
VM1000 offer protection function of user password. When FE.00 set as nonzero,
namely user password, the password come into effect after exiting the function code editing.
Press PRG again, it will indicate “.....”. User password must be correctly input in
order to access common menu. Otherwise, it cannot enter.
If you want to cancel code protection function, it needs to use passwords to enter and
set FE.00 as 0.
To Next Page
Loading...
Need help?
General
