1. Introduction
27
[12] Left warming chamber temperature area
The current temperature of the left warming chamber is displayed.
Touch this area to move to the temperature setting screen. Refer to 2.2.1
Temperature Setting for Each Part of the Instrument for details.
[13] Right warming chamber temperature area
The current temperature of the right warming chamber is displayed.
Touch this area to move to the temperature setting screen. Refer to 2.2.1
Temperature Setting for Each Part of the Instrument for details.
[14] Hot plate temperature area
The current temperature of the hot plate is displayed. Touch this area
to move to the temperature setting screen. Refer to 2.2.1 Temperature
Setting for Each Part of the Instrument for details.
A temperature is displayed separately for the left and right, but the
temperature setting is the same.
[15] Cold spot
A cooling spot*. The cold spot temperature cannot be set. (* 15°C or
below)
[16] Start time display area
Auto operation (preparing/operating): The day of the week and time at
which the current operation was started, are displayed.
Auto operation (paused): The day of the week and time at which the next
operation will be started are displayed.
Refer to 2.2.3 Setting the Schedule of the Auto Operation (with the
Auto Cryo Mode) for details. This area is not displayed during manual
operation.
[17] End time display area
Auto operation (preparing/operating): The day of the week and time at
which the current operation will end are displayed.
Auto operation (paused): The day of the week and time at which the next
operation will end are displayed.
Refer to 2.2.3 “Setting the Schedule of the Auto Operation (with the
Auto Cryo Mode)” for details. This area is not displayed during manual
operation.
To Next Page
Loading...
Need help?
General
